Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
- 3. General data
   - 3.1. Cars with petrol engines
      3.1.1. Masses and transfer numbers
      3.1.2. Operational liquids
      - 3.1.3. Changes in a car design from 1984 to 1986.
         3.1.3.1. Engine
         3.1.3.2. Head of the block of cylinders
         3.1.3.3. Block of cylinders of the engine
         3.1.3.4. Krivoshipno-shatunny mechanism
         3.1.3.5. Bent shaft
         3.1.3.6. System of gas distribution
         3.1.3.7. Engine mount
         3.1.3.8. Cooling system
         + 3.1.3.9. Carburetor
         3.1.3.10. System of injection of fuel
         3.1.3.11. System of ignition
         3.1.3.12. Coupling
         3.1.3.13. Mechanical four-speed transmission
         3.1.3.14. Mechanical five-speed transmission
         + 3.1.3.15. Automatic Ford A 4 LD transmission
         3.1.3.16. Power shaft and back bridge
         3.1.3.17. System of steering with the hydraulic booster
         3.1.3.18. Forward suspension bracket
         3.1.3.19. Back suspension bracket
         3.1.3.20. Brake system
         + 3.1.3.21. Electric equipment
         3.1.3.22. General data
      + 3.1.4. Changes in a car design from 1987 to 1989.
      + 3.1.5. Changes in a car design from 1990 to February, 1993.
   + 3.2. Cars with diesel engines
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


a773976c



3.1.3.14. Mechanical five-speed transmission

GENERAL INFORMATION

Installation of the new needle bearing of an intermediate shaft of the mechanical 5-staged transmission

And – remote rings,

In – bearing needles

Bearings of an intermediate shaft

Since May, 1983 (a code of date of production "DL") the new solution of placement of an intermediate shaft in bearings in all five-speed transmissions is entered. Length of needles of bearings is changed to 25,75 mm (before 33 mm).

When replacing needle bearings in transmissions of earlier date of production it is possible to use new bearings, at the same time it is necessary to establish surely two additional (not applied in the new decision) remote rings with factory designation 839 E-7125-AA-6094966.


Prevention

Two additional rings it is necessary to have the bearing.


Other information concerning a technical characteristic, adjustment and repair of the mechanical five-speed transmission is provided in subsection 6.2.