Ford Sierra

1982-1993 of release

Repair and operation of the car


Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
- 3. General data
   + 3.1. Cars with petrol engines
   - 3.2. Cars with diesel engines
      - 3.2.1. Changes in a car design from 1988 to 1993.
         3.2.1.1. Dm3 engine 2,3
         + 3.2.1.2. Dm3 engine 1,8
         + 3.2.1.3. Fuel system
         + 3.2.1.4. The repair which is not demanding removal of the engine
         3.2.1.5. Removal and installation of the engine
         3.2.1.6. Dismantling of the engine
         3.2.1.7. Check of details
         3.2.1.8. Check of gaps of a bent shaft and rods
         3.2.1.9. Assembly of the engine
         3.2.1.10. Lubrication system
         3.2.1.11. Cooling system
         3.2.1.12. Coupling
         3.2.1.13. Mechanical MT 75 five-speed transmission
         3.2.1.14. Power shaft and back bridge
         3.2.1.15. System of steering
         3.2.1.16. Forward suspension bracket
         3.2.1.17. Brake system
         3.2.1.18. Electric equipment
         3.2.1.19. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


a773976c



3.2.1.6. Dismantling of the engine
PERFORMANCE ORDER
1. To remove a turbocompressor together with a final collector.
2. To merge oil from the engine.
3. To remove the leading part and a clutch plate.
4. To remove a flywheel from a bent shaft.
5. To take off maple a belt of the drive of the pump of cooling liquid.
6. To take off maple a generator drive belt.
7. To remove a head of the block of cylinders (see subsection 3.2.1.4.2).
8. To block a bent shaft and to unscrew a bolt of fastening of a pulley of a bent shaft.
9. To remove a pulley from a bent shaft.
10. To remove the fuel pump (see subsection 3.2.1.3.3).
11. To remove the generator.
12. To remove the air filter.
13. To remove the oil pump.
14. To remove a pulley from an intermediate shaft.
15. To remove a sealing ring from an intermediate shaft.
16. To unscrew two bolts of fastening of a basic flange of an intermediate shaft and to take an intermediate shaft.
17. To remove the pump of cooling liquid.
18. To remove the oil pallet.
19. To remove a pulley from a bent shaft.
20. To remove a grid of an oil receiver of the oil pump.
21. To designate and uncover rods.
22. After designation of rods to take them together with pistons from the block of cylinders of the engine.
23. To designate and uncover radical bearings.
24. To remove a bent shaft.
25. To remove and designate inserts of radical bearings and persistent half rings of a bent shaft.