Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
- 3. General data
   + 3.1. Cars with petrol engines
   - 3.2. Cars with diesel engines
      - 3.2.1. Changes in a car design from 1988 to 1993.
         3.2.1.1. Dm3 engine 2,3
         + 3.2.1.2. Dm3 engine 1,8
         + 3.2.1.3. Fuel system
         + 3.2.1.4. The repair which is not demanding removal of the engine
         3.2.1.5. Removal and installation of the engine
         3.2.1.6. Dismantling of the engine
         3.2.1.7. Check of details
         3.2.1.8. Check of gaps of a bent shaft and rods
         3.2.1.9. Assembly of the engine
         3.2.1.10. Lubrication system
         3.2.1.11. Cooling system
         3.2.1.12. Coupling
         3.2.1.13. Mechanical MT 75 five-speed transmission
         3.2.1.14. Power shaft and back bridge
         3.2.1.15. System of steering
         3.2.1.16. Forward suspension bracket
         3.2.1.17. Brake system
         3.2.1.18. Electric equipment
         3.2.1.19. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


a773976c



3.2.1.10. Lubrication system

GENERAL INFORMATION

Lubrication system

1 – oil pallet,

2 – the pipeline of supply of oil to the pump,

3 – laying,

4 – the oil pump with an arm,

5 – cover of the oil pump,

6 – perepuskny valve,

7 – oil filter

Removal and installation of the oil pump

PERFORMANCE ORDER
1. To unscrew an oil filter.
2. To unscrew four bolts of fastening of the oil pump to the block of cylinders of the engine.
3. To remove the oil pump.
4. To take laying of round section.
5. To establish new laying of round section.
6. To fill in in the oil cm3 pump 10.
7. To install the oil pump.
8. To screw up four bolts of fastening of the oil pump to the block of cylinders of the engine.
9. To screw an oil filter.

Check of pressure of oil

PERFORMANCE ORDER
1. To disconnect the electric socket from the oil pressure sensor.
2. To unscrew the oil pressure sensor.
3. To the place of the sensor to screw up the manometer for measurement of pressure of oil.
4. To start the engine and to warm up it up to the normal working temperature.
5. To read oil pressure size idling and at the speed of the engine of 2000 rpm.
6. If pressure of oil does not correspond to the required values (see subsection 3.2.1.2.6), then it is necessary to check in turn:
      – perepuskny pump valve;
      – pollution of a grid of an oil receiver of the oil pump;
      – fastening and capacity of the pipeline of supply of oil to the pump;
      – degree of wear of the oil pump (excessive gaps of gear wheels of the oil pump).
7. To switch off the engine.
8. To disconnect the manometer.
9. To screw up the oil pressure sensor.
10. To connect the electric socket to the oil pressure sensor.