Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
- 4. Engines
   - 4.1. Petrol engines
      + 4.1.1. Technical characteristics
      4.1.2. Adjustment of gaps of valves
      + 4.1.3. System of ignition
      - 4.1.4. Fuel system
         + 4.1.4.1. The Ford carburetor with the changeable section of the diffuser
         - 4.1.4.2. Weber 32/36 DGAV carburetor
            4.1.4.2.1. Removal and installation of the carburetor
            4.1.4.2.2. Adjustment of provision of a float
            4.1.4.2.3. Adjustment of the starting gate
            4.1.4.2.4. Check and adjustment of the automatic starting arrangement
            4.1.4.2.5. Adjustment of speed of idling of the engine and contents WITH
      + 4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and installation of the engine
      4.1.7. Dismantling of the engine
      4.1.8. Identification of the interacting parts
      4.1.9. Assembly of the engine
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System of gas distribution
      4.1.13. Lubrication system
      + 4.1.14. Cooling system
      4.1.15. Suspension bracket of the power unit
      4.1.16. System of production of the fulfilled gases
   + 4.2. Diesel engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


a773976c



4.1.4.2.1. Removal and installation of the carburetor

Removal

PERFORMANCE ORDER
1. To switch-off the accumulator and to remove the air filter.
2. Being careful, to unscrew a stopper of a broad tank.
3. To remove hoses of cooling liquid from the starting arrangement and to muffle them.
4. To disconnect a cable of management of a butterfly valve.
5. To remove a hose of supply of fuel to the carburetor.
6. To remove from the carburetor a vacuum hose from the ignition distributor.
7. To unscrew 4 fixing nuts and to remove the carburetor.
8. To close an opening of an inlet collector rags.

Installation

PERFORMANCE ORDER
1. Installation of the carburetor is made in the sequence of the return to removal.
2. After installation it is necessary to check: level of cooling liquid and content of carbon monoxide and also to adjust idling turns.