Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
- 4. Engines
   - 4.1. Petrol engines
      + 4.1.1. Technical characteristics
      4.1.2. Adjustment of gaps of valves
      + 4.1.3. System of ignition
      + 4.1.4. Fuel system
      + 4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and installation of the engine
      4.1.7. Dismantling of the engine
      4.1.8. Identification of the interacting parts
      4.1.9. Assembly of the engine
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System of gas distribution
      4.1.13. Lubrication system
      + 4.1.14. Cooling system
      4.1.15. Suspension bracket of the power unit
      4.1.16. System of production of the fulfilled gases
   + 4.2. Diesel engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


a773976c



4.1.12. System of gas distribution

SEALING RING OF THE CAM-SHAFT

Replacement

PERFORMANCE ORDER
1. To disconnect a wire of weight from the accumulator and to merge liquid from the cooling system (see subsection 4.1.14.1).
2. To disconnect the top and lower elastic pipeline from a radiator.
3. To remove a casing of a gear belt. To weaken bolts of fastening of the tension device, to move its roller, overcoming spring resistance and to tighten bolts of fastening of the tension device (see rice. Bolts of fastening of a casing of a belt).
4. To take off a gear belt.
5. To remove a pulley and a basic plate of longitudinal installation from a cam-shaft.
6. To remove a sealing ring of a cam-shaft by means of adaptation 21.008 A.
7. To oil a new sealing ring of a cam-shaft, to install it in adaptation 21.009 A and to press a ring into a head of the block of cylinders.
8. To establish a basic plate and a pulley on a cam-shaft.
9. To put on a gear belt, to establish cranked and distributive shaft on tags (see rice. Adjusting signs of system of gas distribution).
10. To pull a gear belt by means of the tension device (see rice. ONS engine knots).
11. To establish a casing of a gear belt.
12. To connect to a radiator elastic pipelines of the cooling system (top and lower).
13. To fill the cooling system with liquid and to remove from it air.
14. To connect a weight wire to the accumulator.

CAM-SHAFT AND INSTALLATION OF GAS DISTRIBUTION

Removal and installation

These actions are described in subsection 4.1.5.2.