Ford Sierra

1982-1993 of release

Repair and operation of the car

Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
- 4. Engines
   - 4.1. Petrol engines
      + 4.1.1. Technical characteristics
      4.1.2. Adjustment of gaps of valves
      + 4.1.3. System of ignition
      + 4.1.4. Fuel system
      + 4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and installation of the engine
      4.1.7. Dismantling of the engine
      4.1.8. Identification of the interacting parts
      4.1.9. Assembly of the engine
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System of gas distribution
      4.1.13. Lubrication system
      + 4.1.14. Cooling system
      4.1.15. Suspension bracket of the power unit
      4.1.16. System of production of the fulfilled gases
   + 4.2. Diesel engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

4.1.6. Removal and installation of the engine

Removal

PERFORMANCE ORDER

1. To disconnect a weight wire from the accumulator.

2. To remove a cowl.

3. To remove the air filter.

4. To merge cooling liquid from the cooling system (to disconnect pipelines from a radiator, a broad tank, the case of the automatic starting arrangement of the carburetor, and also a heater).

5. To disconnect electric wires from the generator, the sensor of temperature of cooling liquid and the sensor of pressure of oil.

6. To remove from the ignition distributor the distributor of high voltage together with wires.

7. To disconnect the multicontact socket from the ignition distributor.

8. To disconnect an accelerator pedal cable from the carburetor.

9. To disconnect fuel and vacuum hoses, and also electric wires from the carburetor.

10. To take off maple a belt and the auxiliary pump of system of steering (if is present at this version). To suspend the auxiliary pump to a car body by means of a soft wire.

11. To unscrew a forward reception pipe from a final collector.

12. To establish таль for raising of the engine (adaptation 21.068) and to raise the engine, and then to unscrew holders of the engine.

13. To unscrew the bolts connecting the engine to the transmission

14. To disconnect electric wires and to remove a starter.

15. To disconnect a weight wire from the engine.

16. To remove the holder located between the engine and the transmission.

17. To prop up the transmission by means of the corresponding elevator and a wide board and to raise a little the transmission.

18. To take carefully the engine, taking at first arms of its fastening to a body cross-piece.

Installation

PERFORMANCE ORDER

1. Installation of the engine is carried out in the return sequence in relation to removal process.

2. To oil shlits of a shaft of coupling of the transmission before connection of these knots.

3. To establish new laying of a forward exhaust pipe.

4. To fill the cooling system with the corresponding liquid and to remove air from the cooling system.

5. To check and in case of need to adjust an ignition advancing corner, and also engine speed idling and concentration WITH in exhaust gases.