Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
- 4. Engines
   - 4.1. Petrol engines
      + 4.1.1. Technical characteristics
      4.1.2. Adjustment of gaps of valves
      + 4.1.3. System of ignition
      - 4.1.4. Fuel system
         - 4.1.4.1. The Ford carburetor with the changeable section of the diffuser
            4.1.4.1.1. Removal and installation of the carburetor
            4.1.4.1.2. Dismantling, check and assembly of the carburetor
            4.1.4.1.3. Adjustment of speed of idling of the engine and contents WITH
            4.1.4.1.4. Adjustment of the starting arrangement
            4.1.4.1.5. Adjustment of a cable of a butterfly valve
            4.1.4.1.6. Removal and installation of a needle shaft
            4.1.4.1.7. Diaphragm of the vacuum regulator
         + 4.1.4.2. Weber 32/36 DGAV carburetor
      + 4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and installation of the engine
      4.1.7. Dismantling of the engine
      4.1.8. Identification of the interacting parts
      4.1.9. Assembly of the engine
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System of gas distribution
      4.1.13. Lubrication system
      + 4.1.14. Cooling system
      4.1.15. Suspension bracket of the power unit
      4.1.16. System of production of the fulfilled gases
   + 4.2. Diesel engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


a773976c

4.1.4.1.5. Adjustment of a cable of a butterfly valve

GENERAL INFORMATION

Fastening of a cable of a butterfly valve

And – an adjusting nut

PERFORMANCE ORDER
1. To disconnect the accumulator and to remove the air filter.
2. To press against the stop a pedal of an accelerator and to record it in this situation.
3. To establish an adjusting nut in situation at which the control unit the carburetor is in the provision of full supply of fuel.
4. To release and to press repeatedly a pedal of an accelerator and to check whether there is a side play in the direction of increase in opening of a butterfly valve. In the presence of a side play to repeat adjustment.
5. To install the air filter and to connect the accumulator.