Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
- 4. Engines
   - 4.1. Petrol engines
      + 4.1.1. Technical characteristics
      4.1.2. Adjustment of gaps of valves
      - 4.1.3. System of ignition
         4.1.3.1. The sensor of impulses with Hall's converter
         4.1.3.2. To distribute ignitions
         4.1.3.3. Switchboard
         4.1.3.4. Remarks on operation
         4.1.3.5. Installation of a corner of an advancing of ignition
         4.1.3.6. Definition of malfunctions
         4.1.3.7. Removal and installation of the distributor of ignition
      + 4.1.4. Fuel system
      + 4.1.5. The repair which is not demanding removal of the engine
      4.1.6. Removal and installation of the engine
      4.1.7. Dismantling of the engine
      4.1.8. Identification of the interacting parts
      4.1.9. Assembly of the engine
      4.1.10. Replacement of pistons
      4.1.11. Removal and installation of an intermediate shaft
      4.1.12. System of gas distribution
      4.1.13. Lubrication system
      + 4.1.14. Cooling system
      4.1.15. Suspension bracket of the power unit
      4.1.16. System of production of the fulfilled gases
   + 4.2. Diesel engine
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


a773976c Чебоксарские межкомнатные двери читать дальше.



4.1.3.4. Remarks on operation

GENERAL INFORMATION

The transistor system of ignition has bigger energy in a chain of high voltage, than classical system of ignition.

In operating time of the engine it is impossible to concern elements of transistor system of ignition, especially wires of high voltage.

Before all operations connected with replacement of elements of system of ignition it is necessary to disconnect the accumulator from car electric equipment.
It is impossible to connect the condenser to the plug of 1 coil of ignition.

It is impossible to connect the plug (+) the accumulator to the plug of 1 coil of ignition as it threatens with damage of the switchboard.

During check of pressure of compression in cylinders of the engine it is necessary to disconnect the switchboard or to connect the plug 4 coils of ignition to the mass of the car.