Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
- 4. Engines
   + 4.1. Petrol engines
   - 4.2. Diesel engine
      + 4.2.1. Technical characteristics
      4.2.2. Check and adjustment of gaps of valves
      + 4.2.3. Fuel system
      + 4.2.4. Nozzles
      4.2.5. Glow plugs
      4.2.6. Check of a compression
      4.2.7. Removal of air from fuel system
      4.2.8. Fuel filter
      4.2.9. Fuel pump, installation of the beginning of injection of fuel
      4.2.10. Adjustment of speed of idling
      - 4.2.11. The repair which is not demanding removal of the engine
         + 4.2.11.1. Head of the block of cylinders
         4.2.11.2. Removal and installation of the engine
         + 4.2.11.3. Dismantling, repair and assembly of the engine
         + 4.2.11.4. Lubrication system
         + 4.2.11.5. Cooling system
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


a773976c



4.2.11.2. Removal and installation of the engine

GENERAL INFORMATION

Holders of an engine mount

1 – right holder,

2 – left holder,

3 – right metal-rubber connector,

4 – left metal-rubber connector,

5 – engine mount cross-piece

Removal

PERFORMANCE ORDER
1. To disconnect and remove the accumulator. To remove a cowl.
2. To remove the air filter and to muffle an entrance air opening of an inlet collector.
3. To merge cooling liquid from the cooling system (see subsection 4.2.11.5.1) and to remove a radiator together with the holder.
4. To disconnect pipelines of a heater of interior of the car.
5. To disconnect fuel hoses.
6. To disconnect electric wires from the engine.
7. To disconnect a forward exhaust pipe from a final collector.
8. To remove the auxiliary pump of system of steering, without disconnecting from it pipelines and to suspend it to a wing.
9. To disconnect an accelerator pedal cable from the fuel pump.
10. To remove a starter.
11. To unscrew bolts of fastening of holders of a suspension bracket from the engine and to prop up system of gas distribution under a coupling case.
12. To unscrew the bolts connecting the engine to the transmission.
13. To hook on a cable for brackets for rise in front of and behind a head of the block of cylinders.
14. By means of the elevator to move the engine forward and to disconnect it from the transmission, and then to lift the engine up and to take it from a motor compartment of the car.

Installation

PERFORMANCE ORDER
1. To install the engine in a motor compartment and to check whether correctly it is established concerning the transmission.
2. To tighten the bolts connecting the engine to the transmission and then bolts of holders of an engine mount.
3. To connect hoses of the cooling system and to fill it with the corresponding liquid.
4. To connect an accelerator pedal cable to the fuel pump and to adjust its tension.
5. To connect fuel hoses and to remove air from fuel system.
6. To establish and connect the accumulator; to install the air filter and a cowl.
7. To start the engine and to check its work.