Ford Sierra

1982-1993 of release

Repair and operation of the car

Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
- 7. Driveshaft and back bridge
   7.1. Technical characteristics
   7.2. Removal and installation of the driveshaft
   7.3. Repair of the intermediate bearing
   7.4. Removal and installation of the back bridge
   7.5. Dismantling and assembly of the back bridge
   7.6. Dismantling and assembly of differential
   7.7. Adjustment of bearings of gear wheels of the main transfer
   7.8. Adjustment of gear wheels of the main transfer
   7.9. Assembly and adjustment of the main transfer
   7.10. Replacement of a sealing ring of a gear wheel of the main transfer
   - 7.11. Half shafts
      7.11.1. Removal and installation
      7.11.2. Dismantling and assembly
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

7.11.2. Dismantling and assembly

PERFORMANCE ORDER

1. To remove collars of fastening of protection covers of hinges of a half shaft.
	2. To cut a casing of hinges and to unbend them by means of passatizhy.
3. By means of the device for compression of springs to remove a half shaft nave from the hinge.
4. To remove an external lock ring of the three-humeral hinge and to designate its situation concerning a half shaft.
5. To move the protection cover along a half shaft and by means of a stripper with three captures to remove the hinge.
6. To remove a lining from artificial material, a casing and the rubber protection cover of the hinge.
7. To take a rubber ring of round section from a nave.
	8. To clear and check all details, to replace worn out or damaged.
9. To establish on a half shaft protective a casing, a casing and a lining from artificial material (the convex surface directed from the hinge).
10. By means of the plug of the corresponding sizes to install the three-humeral hinge on a half shaft. Both hinges of a half shaft have to be displaced from each other on a corner 60 ° (using the designations made during dismantling).
11. To establish a lock ring.
12. By means of the device for compression of springs to install a half shaft nave on the hinge. To fill the hinge with 15 grams of solid lubricant.
13. To establish a rubber ring of round section on a nave.
14. By means of the corresponding stripper to establish a casing of the three-humeral hinge, having its edge in hinge flutes.
15. To clamp a casing on all perimeter.
16. To fill hinges with 65-85 grams of solid S-MIC 75 F or SQM-IC 9004 lubricant.
17. To establish rubber protective a casing and to clamp new collars of fastening of casings.