Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
- 7. Driveshaft and back bridge
   7.1. Technical characteristics
   7.2. Removal and installation of the driveshaft
   7.3. Repair of the intermediate bearing
   7.4. Removal and installation of the back bridge
   7.5. Dismantling and assembly of the back bridge
   7.6. Dismantling and assembly of differential
   7.7. Adjustment of bearings of gear wheels of the main transfer
   7.8. Adjustment of gear wheels of the main transfer
   7.9. Assembly and adjustment of the main transfer
   7.10. Replacement of a sealing ring of a gear wheel of the main transfer
   - 7.11. Half shafts
      7.11.1. Removal and installation
      7.11.2. Dismantling and assembly
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment





7.11. Half shafts

7.11.1. Removal and installation

Removal

PERFORMANCE ORDER
1. To lift the car and to remove a back wheel from the relevant party.
2. To remove the brake drum.
3. To unscrew a nut of fastening and to remove a nave flange by means of the corresponding stripper.
4. To unscrew nuts of fastening of a nave of a wheel to the lever of a back suspension bracket.
5. To remove a nave of a wheel and to disconnect the bearing brake board.
6. To attach the bearing brake board two bolts to the lever of a back suspension bracket.
7. To take a half shaft.

Prevention

Three-humeral hinges of a half shaft cannot be turned one concerning another on a corner more than 13 ° as it breaks their working capacity.


Installation

PERFORMANCE ORDER
1. To insert the end of a half shaft into a shlitsevy opening of a box of differential.
2. To attach a nave of a wheel and the bearing brake board to the lever of a back suspension bracket.
3. To insert four bolts of fastening, a casing of the hinge and new collars of fastening of a casing.
4. To establish a flange of a nave of a wheel and to put the clamp of fastening of a nave without final tightening.
5. To install the brake drum and a back wheel.
6. To lower the car and to tighten the corresponding moments a nut of a nave of a back wheel, and also a nut of bolts of fastening of a wheel.