Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
- 7. Driveshaft and back bridge
   7.1. Technical characteristics
   7.2. Removal and installation of the driveshaft
   7.3. Repair of the intermediate bearing
   7.4. Removal and installation of the back bridge
   7.5. Dismantling and assembly of the back bridge
   7.6. Dismantling and assembly of differential
   7.7. Adjustment of bearings of gear wheels of the main transfer
   7.8. Adjustment of gear wheels of the main transfer
   7.9. Assembly and adjustment of the main transfer
   7.10. Replacement of a sealing ring of a gear wheel of the main transfer
   + 7.11. Half shafts
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


a773976c



7.6. Dismantling and assembly of differential

GENERAL INFORMATION

Measurement of an axial gap between semi-axial gear wheels and a box of differential

Dismantling of differential is obligatory only when the gap between semi-axial gear wheels and a box of differential exceeds value of 0,15 mm or when satellites or semi-axial gear wheels are damaged.

Dismantling

PERFORMANCE ORDER
1. By means of adaptation 15.026 A to remove differential box bearings.
2. To install a differential box in a vice, to weaken bolts of fastening of the conducted gear wheel of the main transfer and to separate a gear wheel with a box, carefully striking in fastening bolts.
3. To unscrew bolts of fastening and to remove a gear wheel from a differential box.
4. To take an adjusting pin of an axis of satellites.
5. To take an axis, satellites and their adjusting laying.

Assembly

PERFORMANCE ORDER
1. To establish semi-axial gear wheels together with new adjusting laying with thickness which is picked up according to earlier measured gaps.
2. To install satellites together with basic laying and an axis.
3. To heat the conducted gear wheel of the main transfer (by its lowering in hot water) and to put on it a differential box. To provide normal centering by installation of four bolts of fastening.
4. After adjustment of installation of gear wheels of the main transfer (see subsection 7.8) to install differential bearings.