1. To establish flanges (8, see rice. Zadny Bridge) of adjustment of a gap of bearings of a box of differential without laying of round section. |
2. To install the oiled differential box bearings, and also the replacing differential box. |
3. To screw up a hand flanges of adjustment of a gap of bearings of a box of differential before contact them with bearings and to tighten a knurled nut of fixing of the replacing box. |
4. To turn repeatedly replacing box for exact laying of rollers of bearings. |
5. To install the indicator of hour type on a case, and to rest its measuring tip against the middle of the replacing box. |
6. To execute one whole revolution of the replacing box and to watch fluctuations of an arrow of the indicator. |
|
7. To install the replacing box in situation in which the arrow of the indicator costs an average situation between extreme indications. Not to rotate the replacing box any more. |
|
8. To install the indicator of hour type on the holder (adaptation 15.008). To rest its measuring tip against a template of adaptation 15.075 and to adjust the indicator. For the bridge 6,5" to use the lower plane of a template, and for the bridge 7" – the top plane. |
9. To rest the holder of the indicator against an end face of a gear wheel of the main transfer, and a measuring tip of the indicator in the middle of the replacing box. |
10. To remove a difference concerning the distance established according to a template. |
11. To correct the measured distance, selecting laying thickness between the internal bearing of the leading gear wheel and a gear wheel of the main transfer so that the deviation from the zero indication of the indicator made no more than 0,01 mm. |
12. After tightening of a nut of fastening of bearings of gear wheels, it should be fullered. |
13. By means of adaptation 15.047 A to establish a new sealing ring of a gear wheel of the main transfer. |
14. To establish a flange of a gear wheel of the main transfer (for connection with the back hinge of the driveshaft) and to tighten a nut of fastening of a flange the corresponding moment. |