| 1. To take off a protective cap of a back wheel and to weaken nuts of fastening of a wheel. |
| 2. To weaken a nave nut on the end of a half shaft. |
| 3. To lift and record a back part of the car, to remove the corresponding wheel. |
| 4. To remove the brake drum (see subsection 10.3). |
| 5. To unscrew a nave nut on the end of a half shaft. |
| 6. By means of a stripper with external captures to remove a wheel nave. |
| 7. To remove from within the bearing brake board a plastic casing of the external driving hinge of a half shaft after a raising the screw-driver of tightening rings on heads of bolts and unscrewing of bolts of fastening of a casing. |
| 8. To unscrew and take four bolts of fastening of the case of wheel bearings to the lever of a suspension bracket and to take the case of hug bearings of a back wheel. |
| 9. To screw in freely two bolts of fastening (on diagonal) cases of hug bearings after its extraction for deduction of the bearing brake board and preservation of a back brake hose. |
| 10. To take from the case of wheel bearings two sealing rings, and also conic bearings (external and internal). |
| 11. To beat out external rings of bearings a core from bronze. |
| 12. To clear the internal surface of the case of wheel bearings. |
| 13. To install in the case by means of adaptation 14.019 external rings of bearings. |
| 14. To grease with lubricant space between bearings and to insert conic bearings into the case. |
| 15. To insert into the case sealing rings by means of adaptation 14.019. |
| 16. To unscrew two bolts holding the bearing brake board and to insert the case of wheel bearings into the bearing brake board. |
| 17. To screw up bolts of fastening of the case of bearings to the lever of a suspension bracket and to tighten them the corresponding moment. |
| 18. To establish a plastic casing of the external driving hinge of a half shaft. |
| 19. To insert a nave flange on a half shaft, to put on laying a half shaft and to put the new clamp without final tightening. |
| 20. To install the brake drum. |
| 21. To put on a wheel, to put the clamps of fastening of a wheel and to lower the car. |
| 22. To tighten the corresponding moment a wheel nave nut on the end of a half shaft and to record it stamping of a cylindrical part of a nut a steel punch in a carving flute. |
| 23. To tighten the corresponding moment of a nut of fastening of a wheel. |
