Ford Sierra

1982-1993 of release

Repair and operation of the car

Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
- 10. Brake system
   10.1. Technical characteristics
   + 10.2. Forward brakes
   - 10.3. Back brakes
      10.3.1. Removal and installation of the reel
      10.3.2. Replacement of brake shoes
      10.3.3. Replacement of the cylinder
   10.4. Removal and installation of the main brake cylinder
   10.5. Removal of air from the brake system
   10.6. Adjustment of the emergency brake
+ 11. Body
+ 12. Electric equipment

a773976c Все торговое оборудование термопринтер star micronics.
скупка телевизоров бу в Москве, скупка сломанных телевизоров.
защита конфиденциальной информации
Лонжа для фигурного катания по материалам
игра в слова

10.3. Back brakes

10.3.1. Removal and installation of the reel


Back brake of DBA


1 – brake drum,
2 – brake shoes,
3 – the bearing board,
4 – cylinder,
5 – lever of the emergency brake,
6 – latch of the mechanism of automatic adjustment of a gap of blocks,
7 – returnable spring of blocks

Hook of a spring of the conductor of a block

The hook of a spring of the conductor of a block – is specified by an arrow.


1. To weaken nuts of fastening of a back wheel.
2. To lift and record a back part of the car, to remove a back wheel.
3. To remove from wheel bolts (if are present) clamps of the brake drum after weakening of their fastening by blows of a chisel (turn to the left).
4. To check whether the emergency brake is switched off.
5. To remove the brake drum from a wheel nave.


Installation of a back brake

1 – returnable spring of blocks,

2 – fastening of a spring of the conductor of a block,

3 – latch of automatic adjustment of a gap

1. To check, damages and wear of the brake drum and also whether the working surface of the reel of the deepenings felt by fingers has. In case of need to peretochit a drum or to replace it.
2. To clear mechanism interiors, having blown it compressed air.
3. To install the brake drum on a wheel nave flange.
4. To establish a back wheel.
5. To lower the car and to tighten nuts of fastening of a wheel the corresponding moment.