Ford Sierra

1982-1993 of release

Repair and operation of the car

Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
- 10. Brake system
   10.1. Technical characteristics
   + 10.2. Forward brakes
   - 10.3. Back brakes
      10.3.1. Removal and installation of the reel
      10.3.2. Replacement of brake shoes
      10.3.3. Replacement of the cylinder
   10.4. Removal and installation of the main brake cylinder
   10.5. Removal of air from the brake system
   10.6. Adjustment of the emergency brake
+ 11. Body
+ 12. Electric equipment

10.3.3. Replacement of the cylinder

Replacement with removal of blocks

PERFORMANCE ORDER

1. To remove a drum and brake shoes.

2. To disconnect the brake pipeline from the cylinder and to muffle its opening the corresponding stopper.

3. To unscrew two bolts of fastening of the cylinder to the bearing board and to take the brake cylinder together with a sealing ring.

4. To install the cylinder together with a new sealing ring and to tighten the corresponding moment two bolts of fastening of the cylinder to the bearing board.

5. To connect the brake pipeline and to tighten its nut the moment of 8 Nanometers.

6. To establish brake shoes and a drum.

7. To remove air from the brake system.

8. To press strongly a brake pedal several times, the knock in back brakes meaning their regulation will not stop yet.

Replacement without removal of brake shoes

PERFORMANCE ORDER

1. To remove the brake drum.

2. To unscrew the brake pipeline from the cylinder and to muffle the pipeline the corresponding stopper.

3. To stretch brake shoes so that the lever of adjustment of a gap removed blocks from the cylinder.

4. To unscrew two bolts of fastening of the cylinder to the bearing board and to take the brake cylinder together with a sealing ring.

5. To install the cylinder together with a new sealing ring and to tighten the corresponding moment two bolts of fastening of the cylinder to the bearing disk.

Berlin 2,0 ^dm3 and komb

6. To weaken the lever of adjustment of a gap, pressing a lever ledge the screw-driver towards the cylinder.

Berlin 1,3 and 1,6 ^dm3

7. To press down a latch of adjustment of a gap by means of the screw-driver, releasing thus the adjusting lever, pressing at the same time back block (asynchronous) to the cylinder.

All types

8. To check correctness of installation of the ends of blocks in grooves of pistons of the brake cylinder.

9. To connect the brake pipeline and to tighten its nut the moment of 8 Nanometers.

10. To remove air from the brake system.

11. To press strongly a brake pedal several times, the knock in back brakes meaning their regulation will not stop yet.