Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
- 9. Suspension brackets
   + 9.1. Forward suspension bracket
   - 9.2. Back suspension bracket
      9.2.1. Technical characteristics
      9.2.2. Replacement of the shock-absorber
      9.2.3. Replacement of a spring of a suspension bracket
      9.2.4. Removal and installation of the lever of a suspension bracket
      9.2.5. Replacement of the metal-rubber plug of a beam of a suspension bracket
      9.2.6. Replacement of hug bearings of a back wheel
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


a773976c упаковочная бумага оптом цены.
Смотрите http://www.the-trench.ru аренда фокус комнаты в центре москвы.
На www.tricolor-56.ru кассетные кондиционеры оренбург.
Морфологический разбор слова.



9.2.2. Replacement of the shock-absorber

GENERAL INFORMATION

Back suspension bracket

1 – beam of a back axis,
2 – slanting lever,
3 – shock-absorber,
4 – suspension bracket spring,
5 – case of wheel bearings,
6 – conic bearings,
7 – sealing ring,
8 – metal-rubber plug of a beam,
9 – metal-rubber plug of the lever

PERFORMANCE ORDER
1. To unhook a luggage carrier covering fragment (a body of Berlin) or to incline forward a back of back sitting and to unscrew in front a luggage carrier bottom covering (a komba body), and also to remove a casing of the top fastening of the shock-absorber.
2. To lift and fix the car.
3. By means of the corresponding elevator to prop up the lever through a wooden lining.
4. To unscrew a bolt of the top fastening of the shock-absorber (in cars with a body of Berlin, on a photo) or to unscrew a nut of the top fastening of the shock-absorber, holding at the same time a shock-absorber rod with a key for internal hexagons (in cars with a komba body).
5. To unscrew a bolt of the lower fastening of the shock-absorber (in cars with a body of Berlin) or to unscrew a nut of the lower fastening of the shock-absorber (in cars with a komba body) and to take the shock-absorber down.
6. For installation of the shock-absorber to perform operations in the return sequence in relation to removal process.