Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
- 9. Suspension brackets
   - 9.1. Forward suspension bracket
      9.1.1. Technical characteristics
      9.1.2. Removal and installation of a rack of a forward suspension bracket
      9.1.3. Dismantling and assembly of a rack of a suspension bracket
      9.1.4. Removal and installation of the stabilizer
      9.1.5. Replacement of the metal-rubber plug of the lever
      9.1.6. Removal and installation of a rotary fist
      9.1.7. Check of installation of forward wheels
      9.1.8. Replacement of hug bearings of a forward wheel
   + 9.2. Back suspension bracket
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


a773976c



9.1.8. Replacement of hug bearings of a forward wheel

GENERAL INFORMATION

Nave of a forward wheel in a section

1 – conic bearings,

2 – sealing ring

PERFORMANCE ORDER
1. To remove a rotary fist of a wheel (see the corresponding description in subsection 9.1.6).
2. To put the clamps (conic surfaces outside) on the bolts of fastening of a wheel located in a nave and to fix in a vice a rotary fist together with a nave, holding for nuts of wheels.
3. To take off a protective cap of an axis of a wheel from the inside of a rotary fist.
4. To unscrew a nut of an axis of a wheel and to take flat laying.
5. To take the internal conic bearing from a rotary fist.
6. To remove a rotary fist from a wheel nave.
7. To extend a sealing ring by means of adaptation 21.051.
8. To beat out external rings of conic bearings by means of a core from bronze.
9. To clear and check technical condition of the taken details. To replace the worn-out or damaged details.
10. To insert by means of adaptation 14.024 new external rings of bearings into a rotary fist as which emphasis serves wooden whetstone.
11. To fill all space between bearings solid lubricant for bearings.
12. To install the external bearing and to press a new sealing ring with space between sealing edges filled with solid lubricant.
13. To establish a rotary fist on a wheel nave.
14. To install the internal conic bearing, to insert flat laying and to tighten new самоконтрящуюся a wheel nave nut the corresponding moment (see subsection 9.1.1)
15. To establish a protective cap of an axis of a wheel from the inside of a rotary fist.
16. To remove a rotary fist from a vice and to unscrew nuts from bolts of fastening of a wheel.

17. To install a rotary fist on the car.