Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
- 9. Suspension brackets
   - 9.1. Forward suspension bracket
      9.1.1. Technical characteristics
      9.1.2. Removal and installation of a rack of a forward suspension bracket
      9.1.3. Dismantling and assembly of a rack of a suspension bracket
      9.1.4. Removal and installation of the stabilizer
      9.1.5. Replacement of the metal-rubber plug of the lever
      9.1.6. Removal and installation of a rotary fist
      9.1.7. Check of installation of forward wheels
      9.1.8. Replacement of hug bearings of a forward wheel
   + 9.2. Back suspension bracket
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment





9.1.6. Removal and installation of a rotary fist

GENERAL INFORMATION

Fastening of a rotary fist of a wheel


1 – bolt of the lower fastening of the shock-absorber,

2 – nut of fastening of steering draft,

3 – nut of fastening of the stabilizer

Removal
PERFORMANCE ORDER
1. To weaken from the relevant party of a nut of a forward wheel.
2. To lift and prop up the car and to remove a forward wheel.
3. To remove a brake support without detachment of hydraulic pipelines and to suspend it to a body by means of a soft wire.
4. To unscrew the screw of fastening of a brake disk and to remove a disk.
5. To take forelocks and to unscrew koronchaty nuts of spherical hinges from a rotary fist.
6. To squeeze out from a rotary fist the spherical hinge of steering draft by means of adaptation 13.006.
7. To squeeze out the spherical hinge of the cross lever from a rotary fist by means of a stripper.
8. To unscrew from a rotary fist tightening a bolt of the lower fastening of a rack of a suspension bracket.
9. To disconnect a suspension bracket rack from a rotary fist by means of adaptation 14.026 and to take a rotary fist.

Installation

For installation of a rotary fist it is necessary to perform operations in the return sequence in relation to removal process.