Ford Sierra

1982-1993 of release

Repair and operation of the car

Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   12.1. Technical characteristics
   12.2. Relay and safety locks
   12.3. Removal and installation of the generator
   12.4. Dismantling and assembly of the generator
   12.5. Adjustment of a tension of a maple belt
   12.6. Starter
   12.7. Windshield screen wiper, knot of indexes and headlight
   12.8. Removal and installation of a combination of devices
   12.9. Adjustment of light of headlights
   - 12:10. System of heating and ventilation
      12.10.1. Removal and installation of a heater
      12.10.2. Fan engine
   + 12:11. Electrical circuitries


12.10.2. Fan engine


1. To disconnect a weight wire from the accumulator.
2. To remove sealing rubber of an air chamber under the forward panel.
3. In a compartment of the engine to unscrew and take a fan casing.
4. To disconnect electric wires from the fan engine (the multicontact socket about the fan) and a weight wire from a body.
5. To unscrew two bolts of fastening and to take the fan.
6. To uncover the fan after a raising of safety clips and a detachment of a fastener from artificial material.
7. To remove a fastening ski lift with the resistor.
8. To disconnect the socket from the engine of the fan and to take from the case the fan engine with a krylchatka.


1. To install in the case the fan engine with a krylchatka, the resistor with a ski lift and to connect electric wires to the engine.
2. To put both halves of the case and to latch a fastener.
3. To install the fan in a body and to tighten nuts of its fastening.
4. To connect sockets of electric wires.
5. To screw a casing of the fan and to insert sealing rubber of an air chamber.
6. To connect a weight wire to the accumulator.