Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   12.1. Technical characteristics
   12.2. Relay and safety locks
   12.3. Removal and installation of the generator
   12.4. Dismantling and assembly of the generator
   12.5. Adjustment of a tension of a maple belt
   12.6. Starter
   12.7. Windshield screen wiper, knot of indexes and headlight
   12.8. Removal and installation of a combination of devices
   12.9. Adjustment of light of headlights
   + 12:10. System of heating and ventilation
   + 12:11. Electrical circuitries


a773976c



12.8. Removal and installation of a combination of devices

GENERAL INFORMATION

Combination of devices

 

And – the main version, L and GL,
In – the Ghia version,
1 – printed circuit board,
2 – case,
3 – casing,
4 – glass,
5 – speedometer,
6 – index of level of fuel and temperature of cooling liquid,
7 – tachometer

Removal

PERFORMANCE ORDER
1. To disconnect a weight wire from the accumulator.
2. To remove top and lower a casing of a steering column.
3. To pick up carefully the small screw-driver and to remove the handle of adjustment of intensity of illumination of a combination of devices, and also the regulator of frequency of faltering work of a screen wiper and to remove the socket of multicontact connection.
4. To unscrew four screws of fastening of a casing of a combination of devices and to take a casing.
5. To unscrew four screws of fastening of a combination of devices and the tax forward a combination of devices from the forward panel is a little. bolts after removal of plastic casings (shooters showed fastening screws).
6. To disconnect a speedometer drive cable, and also (on the right side) the multicontact socket of connection of electric wires.

Installation

For installation of a combination of devices it is necessary to perform operations in the return sequence in relation to removal process.