Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   12.1. Technical characteristics
   12.2. Relay and safety locks
   12.3. Removal and installation of the generator
   12.4. Dismantling and assembly of the generator
   12.5. Adjustment of a tension of a maple belt
   12.6. Starter
   12.7. Windshield screen wiper, knot of indexes and headlight
   12.8. Removal and installation of a combination of devices
   12.9. Adjustment of light of headlights
   + 12:10. System of heating and ventilation
   + 12:11. Electrical circuitries


a773976c



12.3. Removal and installation of the generator

GENERAL INFORMATION

Removal of the generator

1 – connection of wires,


2 – lower bolts of fastening


Removal

PERFORMANCE ORDER
1. To disconnect a weight wire from the accumulator, and also the socket of multicontact connection behind the generator (after removal of a safety fastener).
2. To weaken bolts of fastening of the generator.
3. To turn the generator to the engine and to take off maple a belt from a generator pulley.
4. To unscrew bolts of fastening and to take the generator.

Installation

PERFORMANCE ORDER
1. To insert the generator, to screw up bolts of its fastening and to tighten them a hand.
2. To connect and fix the socket of multicontact connection of wires behind the generator.
3. To establish and pull maple a belt (1 – a bolt of the tension device, And – a belt deflection (And = 10 mm)).
4. To tighten a bolt of adjustment of a tightness, then a forward bolt of the lower fastening and, at last, a back bolt of the lower fastening of the generator.
5. To connect a weight wire to the accumulator.
6. To check a tension of a maple belt. In case of need to weaken bolts of fastening of the generator, to pull maple a belt and again to tighten bolts, since a bolt of adjustment of a tightness, and then a bolt of forward and back fastening of the generator.