| 1. To clear and check technical condition of all details; to replace the worn-out or damaged details. |
| 2. To insert into the case the nylon directing ring on the right side of the case of steering transfer. |
| 3. To attach a gear lath to the case of steering transfer and to establish a lath on average situation. |
| 4. To install a driving gear wheel in the case of steering transfer together with the bearing. |
| 5. To insert laying and a cover of the case of a driving gear wheel. |
| 6. To install a pusher in the case of steering transfer. |
| 7. To install the indicator of hour type together with a bracket (15.046 and 13.008). |
| 8. To establish on a razmetochny plate a sensor arrow on zero. |
| 9. To install the sensor on a pusher, and to rest its measuring tip against the case of steering transfer. |
| 10. To write down the indication (A) during movement of a gear lath from one extreme situation to another. |
11. Thickness (E) of laying which should be established under a pusher cover, are defined in millimeters on the basis of expression:
Е = And j + F
where:
And – the indication of the sensor of indicator type;
j = 0,14 mm – laying thickness;
F = 0,015... 0,150 mm – a constructive gap. |
| 12. To establish a pusher spring, adjusting laying of the calculated thickness, laying, a cover and to tighten bolts of fastening of a cover. |
| 13. By means of a dynamometer to check resistance moment during turn of a driving gear wheel of steering transfer (see subsection 7.1). |
| 14. To move a gear lath in the case against the stop to the left and to clamp in a vice with soft cheeks. |
| 15. To connect steering thirsts for a gear lath and to put on protective cases of transfer of a casing. |
| 16. To establish new collars of fastening of casings. |
| 17. To connect to steering drafts tips with spherical hinges and to record them from unscrewing. |
