Ford Sierra

1982-1993 of release

Repair and operation of the car



Ford Siyerra
- 1.2. Identification of the car
   1.3. Raising of the car
   1.4. Towage
   1.5. Combination of devices
   1.6. Cowl
   1.7. Start of the engine
   1.8. Lighting and alarm system
   1.9. Replacement of bulbs
   1.10. Ventilation and heating of salon
   1.11. Doors
   1.12. The hatch and a luggage carrier on a roof
   1.13. Seats and head restraints
   1.14. Mirrors
   1.15. Control bulb of fastening of seat belts
   1.16. Replacement of a wheel
+ 2. Maintenance
+ 3. General data
+ 4. Engines
+ 5. Coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


a773976c



1.9. Replacement of bulbs

GENERAL INFORMATION

Bulbs of near and far light

Bulbs of near and far light, and also marker lights are available from a motor compartment.

PERFORMANCE ORDER
1. To remove a casing from a back part of a headlight, turning it counterclockwise.
2. To disconnect the socket of electric wires (In).
3. To remove a spring of fastening of a bulb (And).
4. To turn the holder of a bulb counterclockwise and to take him from a headlight.
5. To replace a bulb.
6. To insert the holder of a bulb into a nest of a headlight and to record it turn against the stop to the right.
7. To establish a spring of fastening and the socket of wires.
8. To check correctness of functioning of a bulb.
9. To fix a casing on a back part of a headlight.

Prevention

It is impossible to touch fingers a glass part of bulbs, in particular halogen. Otherwise before installation of a bulb in a nest it should be washed out spirit solution.


Marker lights

PERFORMANCE ORDER
1. To remove a casing from a back part of a headlight.
2. To take the holder of a bulb (under the holder of a bulb of near and far light).
3. To replace a bulb.
4. To insert the holder into a nest.
5. To be convinced that the boss of a bulb is well fixed.
6. To check installation and functioning of a bulb.
7. To fix a casing on a back part of a headlight.

Bulbs of high beam headlamps

Some versions of cars are equipped with high beam headlamps with halogen bulbs.

PERFORMANCE ORDER
1. To remove a bracket (A) of fastening of a cover and to uncover a headlight.
2. To squeeze a spring (V) of fastening of a bulb and to remove it. To take a bulb (C).
3. To disconnect the socket of wires.
4. To connect a new bulb to the socket of electric wires and to insert it into a headlight.
5. To establish a spring of fastening of a bulb.
6. To establish a cover and a bracket of fastening.

Forward indexes of turns

PERFORMANCE ORDER
1. From the back party of a bumper to remove outside a fastening clip.
2. To get from a bumper a bulb of the forward index of turn forward; in the Ghia version the bulb of the forward index of turn adheres the lever located under the top fastening of a bumper which should be removed outside for extraction of a bulb.
3. To turn the holder of a bulb of the forward index of turn to the left and to take it.
4. To press a bulb, to turn it to the left and to take.
5. To establish a new bulb in the holder, turning it to the right, and then to fix the index of turn, performing the above described operations in the return sequence.

Back lamp

Bulbs of a back lamp are located in the holder's knot available from within a luggage carrier.

PERFORMANCE ORDER
CARS WITH THE BODY LIKE BERLIN AND THE SEDAN
1. To take the holder's knot, moving the fastening stopper located on the end of this knot.
2. In each knot of the holder four bulbs are located: bulb of a signal of braking (1), bulb of a backing (2), bulb of a marker light and back fog lamp (3) and bulb of the back index of turn (4).
3. To press a bulb which has to be replaced, turn it and take from the holder's knot.
4. To establish a new bulb in the holder's knot, to turn it, and then to press the holder's knot before blocking of a stopper of fastening.
CARS WITH THE BODY LIKE KOMBA
1. Having opened a luggage carrier by means of the screw-driver to turn a stopper of fastening and to remove a casing of a back lamp.
2. To remove plates of fastening of knot of the holder (A) and to take it. In each knot of the holder five bulbs are located: bulb of a backing (1), bulb of marker back light (2), bulb of the back index of turn (3), bulb of a back fog lamp (4), bulb of the alarm system of braking (5).
3. To press a bulb which has to be replaced, turn it and take from the holder's knot.
4. To establish a new bulb in the holder's knot, to turn it, and then to fix the holder's knot.

Illumination of registration plate

PERFORMANCE ORDER
1. By means of the thin screw-driver it is careful to take knot of the lighting lamp of registration plate from a nest in a rear bumper.
2. To turn to the left and to take the holder of a bulb.
3. To replace a bulb which is pressed in the holder.
4. To establish the holder and to fix knot of the lighting lamp of registration plate in a rear bumper.

Illumination of a luggage carrier

And the Sedan is present at some versions of equipment of a body of type of Berlin a bulb of illumination of a luggage carrier.

PERFORMANCE ORDER
1. By means of the screw-driver it is careful to remove a bulb plafond.
2. Turning a cartridge counterclockwise to take it from a lamp plafond, and then to get from it a bulb.

Lighting lamps of salon

PERFORMANCE ORDER
1. Having installed the switch in average situation (the lamp is switched off).
2. By means of the screw-driver it is necessary to get a cartridge of a bulb, and then to take a bulb.