Ford Sierra

1982-1993 of release

Repair and operation of the car

Ford Siyerra
+ 1.2. Identification of the car
+ 2. Maintenance
+ 3. General data
+ 4. Engines
- 5. Coupling
   5.1. Technical characteristics
   5.2. Removal and installation of coupling
   5.3. Replacement of the needle bearing
   5.4. Replacement of a cable of coupling
   5.5. Coupling pedal mechanism
   5.6. Replacement of a pedal of coupling
   5.7. Release bearing of coupling
+ 6. Transmissions
+ 7. Driveshaft and back bridge
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

5.4. Replacement of a cable of coupling

Removal

PERFORMANCE ORDER

1. To install the car over a viewing hole or to lift it on the elevator.
2. To remove a casing of forks of switching off of coupling from a coupling case after removal of a spring hook.
3. To remove a ratchet stopper from the gear sector, having enclosed the corresponding wooden whetstone under a coupling pedal.
	4. To disconnect the end of a cable from coupling switching off forks, moving its end down, and then forward.
5. To remove the left part of an upholstery about pedals.
	6. To unhook a cable from a pedal with the gear sector and to move it through an opening between a pedal and the gear sector.
7. To extend a cable through an opening of a forward partition in a motor compartment.

Installation

PERFORMANCE ORDER

1. To insert a cable through an opening in a forward partition from a motor compartment, to carry out it between a pedal of coupling and the gear sector and to hook on its end on this sector.

2. To pull a cable forward to extend it from a cover and to hook on its other end on coupling switching off forks.

3. To fix a rubber casing together with a spring hook on a coupling case.

4. To extract wooden whetstone from under a coupling pedal.

5. To establish into place earlier removed upholstery about pedals.

6. To lower the car.

QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE